Skip to content
Fault code dictionary (DTC)

P0CB7 — HV battery temp sensor P: circuit fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe battery control unit found a general fault in the circuit of temperature sensor P. The code does not specify whether the signal is too high, too low or unstable: it only says the circuit is not working as expected. Which sensor in the pack is P depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV system warning light on
Limited power or limp mode
Slowed charging
Abnormal battery ventilation
Fault message on the dashboard

Common causes

Corroded or loose sensor connector
Damaged, broken or shorted wiring
Failed sensor
Fault in the battery management unit
Damage inside the battery pack

What to do

A reading with a scan tool suited to hybrids and EVs is needed, to see the other stored codes and what the sensor reports. The technician can then tell wiring from sensor. Have it checked soon, because the battery uses this data to protect itself. High voltage work is for qualified personnel.

How to read code P0CB7

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0CB7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (B7) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0CB7 mean?

HV battery temp sensor P: circuit fault. The battery control unit found a general fault in the circuit of temperature sensor P. The code does not specify whether the signal is too high, too low or unstable: it only says the circuit is not working as expected. Which sensor in the pack is P depends on the manufacturer.

Can I keep driving with code P0CB7 active?

With caution: limp mode possible, have it checked soon

Common causes — P0CB7

Corroded or loose sensor connector Damaged, broken or shorted wiring Failed sensor Fault in the battery management unit Damage inside the battery pack

How do you fix code P0CB7?

A reading with a scan tool suited to hybrids and EVs is needed, to see the other stored codes and what the sensor reports. The technician can then tell wiring from sensor. Have it checked soon, because the battery uses this data to protect itself. High voltage work is for qualified personnel.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes