P0CEC — Hybrid/EV electronics coolant pump A control circuit high
| Meaning | The control unit detected a higher than expected voltage on the wire commanding the coolant pump for the power electronics. It can mean a short to supply, a broken wire, or a problem in the circuit driving the pump. |
| Family | Powertrain (P) |
Typical symptoms
Pump stopped or always at full speed
Reduced or limited power
Slowed or interrupted charging
Cooling fans very active
Common causes
Broken wire or connector with a backed-out terminal
Corroded or wet connector
Pump with faulty internal electronics
Faulty pump control unit
What to do
How to read code P0CEC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0CEC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (EC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0CEC mean?
Hybrid/EV electronics coolant pump A control circuit high. The control unit detected a higher than expected voltage on the wire commanding the coolant pump for the power electronics. It can mean a short to supply, a broken wire, or a problem in the circuit driving the pump.
Can I keep driving with code P0CEC active?
With caution: limp mode possible, have it checked soon
Common causes — P0CEC
Control wire touching the supply voltage Broken wire or connector with a backed-out terminal Corroded or wet connector Pump with faulty internal electronics Faulty pump control unit
How do you fix code P0CEC?
Check the pump connector and wiring for loose terminals, corrosion or damaged wires. If the pump is not circulating coolant the electronics can overheat: have the car checked soon, especially if power is limited.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0CEB — Hybrid/EV electronics coolant pump A control circu...
- Next code: P0CED — Hybrid/EV electronics coolant pump A enable circui...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open