Skip to content
Fault code dictionary (DTC)

P0CFE — Charging Control Pilot switch A stuck on

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe charging control unit found that the switch managing the Control Pilot signal stays active when it should be off. The Control Pilot is the wire the car and the charging station use to talk to each other. The unit can no longer trust that exchange, so it may limit or block charging.
FamilyPowertrain (P)

Typical symptoms

Charging does not start or stops right away
Warning light for the charging system or the hybrid/electric vehicle
The charging station reports a communication error with the car
The connector stays locked or charging is erratic
It works on some charging stations and not on others

Common causes

Fault in the electronics of the on-board charger
Damaged or corroded wiring or connector at the charge port
Moisture or dirt in the charge port
Faulty charging station or cable
Software problem in the charging control unit

What to do

Try another charging station and another cable to find out whether the fault is in the car or in the outside equipment. Look into the charge port for dirt, water, or bent or blackened pins. If the fault stays, have the car checked at a workshop equipped for high-voltage vehicles. Do not touch the orange high-voltage cables.

How to read code P0CFE

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0CFE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (FE) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0CFE mean?

Charging Control Pilot switch A stuck on. The charging control unit found that the switch managing the Control Pilot signal stays active when it should be off. The Control Pilot is the wire the car and the charging station use to talk to each other. The unit can no longer trust that exchange, so it may limit or block charging.

Can I keep driving with code P0CFE active?

With caution: limp mode possible, have it checked soon

Common causes — P0CFE

Fault in the electronics of the on-board charger Damaged or corroded wiring or connector at the charge port Moisture or dirt in the charge port Faulty charging station or cable Software problem in the charging control unit

How do you fix code P0CFE?

Try another charging station and another cable to find out whether the fault is in the car or in the outside equipment. Look into the charge port for dirt, water, or bent or blackened pins. If the fault stays, have the car checked at a workshop equipped for high-voltage vehicles. Do not touch the orange high-voltage cables.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes