P0D3A — Charger A input current sensor: signal too low
| Meaning | The onboard charger control unit read a signal from the input current sensor (charging port side) that is lower than expected. This sensor measures how much current enters the car while charging. The code points to a problem in the sensor circuit, not necessarily a failed charger. |
| Family | Powertrain (P) |
Typical symptoms
Plug-in charging does not start or stops partway
Charging slower than usual
Charge time that does not match what is displayed
In some cases reduced power while driving
Common causes
Sensor wire shorted to ground
Faulty current sensor
Internal fault in the charger module
Incorrect sensor supply or ground
What to do
How to read code P0D3A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0D3A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0D3A mean?
Charger A input current sensor: signal too low. The onboard charger control unit read a signal from the input current sensor (charging port side) that is lower than expected. This sensor measures how much current enters the car while charging. The code points to a problem in the sensor circuit, not necessarily a failed charger.
Can I keep driving with code P0D3A active?
With caution: limp mode possible, have it checked soon
Common causes — P0D3A
Damaged, corroded or loose sensor connector or wiring Sensor wire shorted to ground Faulty current sensor Internal fault in the charger module Incorrect sensor supply or ground
How do you fix code P0D3A?
Start by visually checking the charger connectors and wiring for moisture, corrosion or pinched wires. If charging fails, avoid repeated attempts. Have live data read by a workshop equipped for hybrid/EV vehicles, since work on high-voltage parts must be done by qualified staff.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0D39 — Hybrid Battery Pack Voltage Variation
- Next code: P0D3B — Charger A input current sensor: signal too high
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range