P0D3B — Charger A input current sensor: signal too high
| Meaning | The charger control unit read a signal from the input current sensor higher than the expected maximum. This can come from an electrical fault in the sensor circuit or from the sensor itself. It does not necessarily mean too much current is flowing: often the measurement is what is wrong. |
| Family | Powertrain (P) |
Typical symptoms
Charging stops suddenly
Charging does not start
Reduced charging power
Possible power limitation while driving
Common causes
Damaged connector or bent pins
Faulty current sensor
Internal fault in the charger module
Electrical noise on the wiring, for example from a damaged cable
What to do
How to read code P0D3B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0D3B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0D3B mean?
Charger A input current sensor: signal too high. The charger control unit read a signal from the input current sensor higher than the expected maximum. This can come from an electrical fault in the sensor circuit or from the sensor itself. It does not necessarily mean too much current is flowing: often the measurement is what is wrong.
Can I keep driving with code P0D3B active?
With caution: limp mode possible, have it checked soon
Common causes — P0D3B
Short to supply voltage in the sensor wiring Damaged connector or bent pins Faulty current sensor Internal fault in the charger module Electrical noise on the wiring, for example from a damaged cable
How do you fix code P0D3B?
Check the visible condition of the cables and connectors on the charger and charging port, without taking apart any high-voltage parts. Try charging from a different station or outlet to see whether the external supply is at fault. If the code stays, have it diagnosed by a workshop approved for high-voltage vehicles.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0D3A — Charger A input current sensor: signal too low
- Next code: P0D3C — Charger A input current sensor: unstable signal
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range