P0D3E — Charger A input voltage sensor: implausible reading
| Meaning | The control unit read a value from the input A voltage sensor that does not match what was expected or the other measurements in the system. The signal is there, but it does not look believable. It may come from the sensor, the wiring or a very unstable power supply. |
| Family | Powertrain (P) |
Typical symptoms
Charging starts and then stops
Charging slower than normal
Charging works only with certain stations
Displayed charge time not reliable
Common causes
Voltage sensor reading inaccurately
High resistance in a connector or in the wiring
Internal fault in the charger module
Damaged charging cable or car inlet
What to do
How to read code P0D3E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0D3E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0D3E mean?
Charger A input voltage sensor: implausible reading. The control unit read a value from the input A voltage sensor that does not match what was expected or the other measurements in the system. The signal is there, but it does not look believable. It may come from the sensor, the wiring or a very unstable power supply.
Can I keep driving with code P0D3E active?
With caution: limp mode possible, have it checked soon
Common causes — P0D3E
Home or station mains supply that is unstable or out of range Voltage sensor reading inaccurately High resistance in a connector or in the wiring Internal fault in the charger module Damaged charging cable or car inlet
How do you fix code P0D3E?
Try charging from a different outlet or station: if the code does not return, the external supply may be the problem. Inspect the cable and inlet by eye. If the fault repeats everywhere, have it checked at a workshop approved for high-voltage vehicles.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0D3D — Charger A input voltage sensor circuit fault
- Next code: P0D3F — Charger A input voltage sensor: signal too low
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range