Skip to content
Fault code dictionary (DTC)

P0D3D — Charger A input voltage sensor circuit fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe charger control unit detected a general fault in the voltage sensor circuit on input A, on the charging port side. This sensor measures the mains voltage reaching the car. Without a reliable reading, the control unit may not start charging, or may stop it for safety.
FamilyPowertrain (P)

Typical symptoms

Warning light or hybrid/EV system error message
Plug-in charging does not start
Charging stops after a short time
Car does not recognise the charging station or outlet
Reduced charging power

Common causes

Damaged wiring or connector on the voltage sensor
Faulty voltage sensor
Incorrect sensor supply or ground
Internal fault in the charger module
Communication problem between the charger and the control unit

What to do

Try charging from another station or outlet to rule out an external supply problem, and inspect the cable and charging port by eye. If the code returns, have it diagnosed by a workshop approved for high-voltage vehicles. Do not open the charger yourself.

How to read code P0D3D

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0D3D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0D3D mean?

Charger A input voltage sensor circuit fault. The charger control unit detected a general fault in the voltage sensor circuit on input A, on the charging port side. This sensor measures the mains voltage reaching the car. Without a reliable reading, the control unit may not start charging, or may stop it for safety.

Can I keep driving with code P0D3D active?

With caution: limp mode possible, have it checked soon

Common causes — P0D3D

Damaged wiring or connector on the voltage sensor Faulty voltage sensor Incorrect sensor supply or ground Internal fault in the charger module Communication problem between the charger and the control unit

How do you fix code P0D3D?

Try charging from another station or outlet to rule out an external supply problem, and inspect the cable and charging port by eye. If the code returns, have it diagnosed by a workshop approved for high-voltage vehicles. Do not open the charger yourself.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes