P0D40 — Charger A input voltage sensor: signal too high
| Meaning | The control unit read a signal from the input A voltage sensor higher than the expected maximum. It can come from an electrical fault in the sensor circuit or from a mains voltage that really is too high. In that case the charger may stop charging to protect itself. |
| Family | Powertrain (P) |
Typical symptoms
Charging does not start
Charging stops suddenly
Reduced charging power
Car reports a problem with the external supply
Common causes
Short to supply voltage in the sensor wiring
Damaged connector or bent pins
Faulty voltage sensor
Internal fault in the charger module
What to do
How to read code P0D40
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0D40 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0D40 mean?
Charger A input voltage sensor: signal too high. The control unit read a signal from the input A voltage sensor higher than the expected maximum. It can come from an electrical fault in the sensor circuit or from a mains voltage that really is too high. In that case the charger may stop charging to protect itself.
Can I keep driving with code P0D40 active?
With caution: limp mode possible, have it checked soon
Common causes — P0D40
Mains voltage too high at the installation or station Short to supply voltage in the sensor wiring Damaged connector or bent pins Faulty voltage sensor Internal fault in the charger module
How do you fix code P0D40?
Try charging from another outlet or station to see whether the problem is external. Inspect the cable and inlet by eye without taking anything apart. If the code returns, have it diagnosed at a workshop approved for high-voltage vehicles.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0D3F — Charger A input voltage sensor: signal too low
- Next code: P0D41 — Charger A input voltage sensor: unstable signal
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range