P0D41 — Charger A input voltage sensor: unstable signal
| Meaning | The control unit detected that the signal from the charger's input A voltage sensor drops in and out or fluctuates erratically. The problem appears intermittently. It may come from a poor contact, the sensor or an unstable power supply. |
| Family | Powertrain (P) |
Typical symptoms
Charging that stops and restarts by itself
Charging that works only sometimes
Highly variable charging times
Occasional hybrid/EV system error messages
Common causes
Wiring with a partly broken wire
Mains or station voltage that fluctuates
Voltage sensor failing intermittently
Damaged charging cable or car inlet
Internal fault in the charger module
What to do
How to read code P0D41
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0D41 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0D41 mean?
Charger A input voltage sensor: unstable signal. The control unit detected that the signal from the charger's input A voltage sensor drops in and out or fluctuates erratically. The problem appears intermittently. It may come from a poor contact, the sensor or an unstable power supply.
Can I keep driving with code P0D41 active?
With caution: limp mode possible, have it checked soon
Common causes — P0D41
Loose, corroded or damp connector Wiring with a partly broken wire Mains or station voltage that fluctuates Voltage sensor failing intermittently Damaged charging cable or car inlet Internal fault in the charger module
How do you fix code P0D41?
Note when the problem appears and with which outlet or station, as it helps diagnosis a lot. Try charging from another source and inspect the cable and inlet by eye. If the fault stays, you need a workshop approved for high-voltage vehicles.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0D40 — Charger A input voltage sensor: signal too high
- Next code: P0D42 — Charger 14 V output voltage sensor circuit fault
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range