P0D42 — Charger 14 V output voltage sensor circuit fault
| Meaning | The control unit detected a fault in the circuit of the sensor that measures the charger's 14-volt output voltage. This output keeps the car's normal 12-volt battery charged, the one that powers lights and control units. Without a reliable reading, charging of the 12-volt battery may be managed poorly. |
| Family | Powertrain (P) |
Typical symptoms
Battery or charging system warning light
12-volt battery that goes flat faster
System start-up sometimes difficult
Instrument cluster or accessories behaving oddly
Common causes
Faulty 14 V output voltage sensor
Old or weak 12-volt battery
Incorrect sensor supply or ground
Internal fault in the converter or charger
What to do
How to read code P0D42
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0D42 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0D42 mean?
Charger 14 V output voltage sensor circuit fault. The control unit detected a fault in the circuit of the sensor that measures the charger's 14-volt output voltage. This output keeps the car's normal 12-volt battery charged, the one that powers lights and control units. Without a reliable reading, charging of the 12-volt battery may be managed poorly.
Can I keep driving with code P0D42 active?
With caution: limp mode possible, have it checked soon
Common causes — P0D42
Damaged sensor wiring or connector Faulty 14 V output voltage sensor Old or weak 12-volt battery Incorrect sensor supply or ground Internal fault in the converter or charger
How do you fix code P0D42?
First have the 12-volt battery condition checked, since a weak one can cause other problems and skew the diagnosis. If the car struggles to start or other warning lights appear, do not put off the check. Diagnosis of the converter should be done at a workshop approved for high-voltage vehicles.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0D41 — Charger A input voltage sensor: unstable signal
- Next code: P0D43 — Charger 14 V output voltage sensor: implausible re...
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range