Skip to content
Fault code dictionary (DTC)

P0D4C — Charger output voltage sensor to hybrid/EV battery: circuit fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected a fault in the circuit of the sensor that measures the charger's output voltage toward the traction battery, the high-voltage one. This measurement is used to control charging of the large battery precisely. Without a reliable reading, charging may be stopped for safety.
FamilyPowertrain (P)

Typical symptoms

Warning light or hybrid/EV system error message
Plug-in charging does not start or stops
Charging slower than normal
State of charge not rising as expected
In some cases reduced power while driving

Common causes

Damaged sensor wiring or connector
Faulty voltage sensor
Incorrect sensor supply or ground
Internal fault in the charger module
Communication problem with the traction battery management

What to do

Avoid repeated charging attempts if they keep stopping. Inspect the cable and charging inlet by eye and try another station. The diagnosis involves high voltage and must be done by an approved workshop: do not open or touch orange components or the traction battery.

How to read code P0D4C

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0D4C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0D4C mean?

Charger output voltage sensor to hybrid/EV battery: circuit fault. The control unit detected a fault in the circuit of the sensor that measures the charger's output voltage toward the traction battery, the high-voltage one. This measurement is used to control charging of the large battery precisely. Without a reliable reading, charging may be stopped for safety.

Can I keep driving with code P0D4C active?

With caution: limp mode possible, have it checked soon

Common causes — P0D4C

Damaged sensor wiring or connector Faulty voltage sensor Incorrect sensor supply or ground Internal fault in the charger module Communication problem with the traction battery management

How do you fix code P0D4C?

Avoid repeated charging attempts if they keep stopping. Inspect the cable and charging inlet by eye and try another station. The diagnosis involves high voltage and must be done by an approved workshop: do not open or touch orange components or the traction battery.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes