B1630 — PRNDL reverse input shorted to ground
| Meaning | The control module reads zero voltage on the selector's reverse circuit (PRNDL), as if the wire were connected to ground. This code is manufacturer-defined and I cannot guarantee the exact meaning on every brand. |
| Family | Body (B) |
Typical symptoms
Dashboard does not show R
Parking sensors or camera do not activate
Warning light or message
The code returns after being cleared
Common causes
Position switch with a contact to ground
Water or corrosion in the connector
Damaged selector wiring
Control module fault (uncommon)
What to do
How to read code B1630
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code B1630 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the manufacturer, so the exact meaning can change from make to make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code B1630 mean?
PRNDL reverse input shorted to ground. The control module reads zero voltage on the selector's reverse circuit (PRNDL), as if the wire were connected to ground. This code is manufacturer-defined and I cannot guarantee the exact meaning on every brand.
Can I keep driving with code B1630 active?
With caution: limp mode possible, have it checked soon
Common causes — B1630
Signal wire pinched or worn, touching the body Position switch with a contact to ground Water or corrosion in the connector Damaged selector wiring Control module fault (uncommon)
How do you fix code B1630?
Check right away whether the reverse lights work, since without them you are not visible when manoeuvring. Then have the wiring, connectors and selector switch checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: B1629 — PRNDL reverse input shorted to battery voltage
- Next code: B1631 — Driver-side left mirror circuit fault
Related codes
- B1600 — PATS anti-theft: no signal from ignition key transponder
- B1601 — PATS anti-theft: incorrect key code from ignition transponde...
- B1602 — PATS anti-theft: invalid key code format from transponder
- B1603 — Anti-theft indicator lamp circuit failure
- B1604 — Anti-theft indicator lamp circuit open
- B1605 — Anti-theft indicator lamp circuit shorted to battery
- B1606 — Anti-theft indicator lamp circuit shorted to ground
- B1607 — Illuminated entry input circuit failure
- B1608 — Illuminated entry input circuit open
- B1609 — Illuminated entry input shorted to battery
- B1610 — Illuminated entry input shorted to ground
- B1611 — Rear wiper mode select switch circuit failure