Skip to content
Fault code dictionary (DTC)

P00A8 — Intake air temperature sensor 2 signal high (bank 2)

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that the signal from the second intake air temperature sensor on bank 2 is above the expected limit. The voltage is too high, as if the air were freezing or as if the circuit were open. It usually points to a detached wire, an open connector or a faulty sensor.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Hard cold starts
Rough idle
Loss of power
Dark smoke or higher consumption when cold

Common causes

Unplugged connector or pins pushed out
Broken signal or ground wire
Faulty sensor with an open circuit
Corrosion in the connector
Cut or torn wiring
Engine control unit fault (rare)

What to do

First check that the bank 2 sensor connector is fully seated and that the wires are intact. This does not normally stop the car at once, but have it checked soon so the engine does not run for long on wrong data.

How to read code P00A8

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P00A8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (A8) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P00A8 mean?

Intake air temperature sensor 2 signal high (bank 2). The control unit detected that the signal from the second intake air temperature sensor on bank 2 is above the expected limit. The voltage is too high, as if the air were freezing or as if the circuit were open. It usually points to a detached wire, an open connector or a faulty sensor.

Can I keep driving with code P00A8 active?

With caution: limp mode possible, have it checked soon

Common causes — P00A8

Unplugged connector or pins pushed out Broken signal or ground wire Faulty sensor with an open circuit Corrosion in the connector Cut or torn wiring Engine control unit fault (rare)

How do you fix code P00A8?

First check that the bank 2 sensor connector is fully seated and that the wires are intact. This does not normally stop the car at once, but have it checked soon so the engine does not run for long on wrong data.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes