P00BE — Air flow sensor B reading too low
| Meaning | The control unit found that the air quantity measured by air flow sensor B is lower than expected. Sensor B is the second air flow sensor, found on engines with two intake branches or two sensors; which one it is depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Lack of power
Unstable idle
Black exhaust smoke on diesels
Possible limp mode
Common causes
Clogged air filter or duct on the B branch
Crushed or damaged duct
Turbo or valves not working correctly
Damaged sensor wiring or connector
Air leaks after the sensor
What to do
How to read code P00BE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00BE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (BE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00BE mean?
Air flow sensor B reading too low. The control unit found that the air quantity measured by air flow sensor B is lower than expected. Sensor B is the second air flow sensor, found on engines with two intake branches or two sensors; which one it is depends on the manufacturer.
Can I keep driving with code P00BE active?
With caution: limp mode possible, have it checked soon
Common causes — P00BE
Dirty or faulty air flow sensor B Clogged air filter or duct on the B branch Crushed or damaged duct Turbo or valves not working correctly Damaged sensor wiring or connector Air leaks after the sensor
How do you fix code P00BE?
Check the filter, ducts and connector on the branch served by sensor B. If power drops a lot or the car goes into limp mode, have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00BD — Air flow sensor A reading too high
- Next code: P00BF — Air flow sensor B reading too high
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2