Skip to content
Fault code dictionary (DTC)

P00C2 — Turbo bypass valve B control circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detects too high a voltage in the control circuit of turbo bypass valve B. It often points to a broken wire, an open contact or a short to supply voltage, but the cause must be confirmed by measurement.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Loss of power
Irregular turbo pressure
Abnormal turbo noises
Possible limp mode

Common causes

Broken wire or unplugged connector
Faulty bypass solenoid
Wiring shorted to supply voltage
Corroded connector contacts
Control unit problem, less common

What to do

Check that the valve connector is fully seated and the wiring is intact. Have the circuit checked soon: until it is fixed, boost may not be managed correctly.

How to read code P00C2

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P00C2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (C2) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P00C2 mean?

Turbo bypass valve B control circuit high. The control unit detects too high a voltage in the control circuit of turbo bypass valve B. It often points to a broken wire, an open contact or a short to supply voltage, but the cause must be confirmed by measurement.

Can I keep driving with code P00C2 active?

With caution: limp mode possible, have it checked soon

Common causes — P00C2

Broken wire or unplugged connector Faulty bypass solenoid Wiring shorted to supply voltage Corroded connector contacts Control unit problem, less common

How do you fix code P00C2?

Check that the valve connector is fully seated and the wiring is intact. Have the circuit checked soon: until it is fixed, boost may not be managed correctly.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes