P00E0 — Charge air cooler coolant temp sensor A: signal too low
| Meaning | The engine computer saw a lower voltage than normal on charge air cooler coolant temperature sensor A. This applies to turbo engines with a liquid-cooled intercooler. To the computer this looks like an extremely hot reading, or a sensor wire shorted to ground. The data it uses to manage boost and the intercooler pump is therefore unreliable. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power or a sluggish engine, especially under load
Possible limp mode with limited torque
Intercooler fan or pump behaving oddly
Fuel consumption that seems higher than usual
Common causes
Pinched or chafed sensor wire touching ground
Corroded, wet or bent connector terminals
Wiring damaged by heat or vibration
Faulty engine computer (rare)
What to do
How to read code P00E0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00E0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (E0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00E0 mean?
Charge air cooler coolant temp sensor A: signal too low. The engine computer saw a lower voltage than normal on charge air cooler coolant temperature sensor A. This applies to turbo engines with a liquid-cooled intercooler. To the computer this looks like an extremely hot reading, or a sensor wire shorted to ground. The data it uses to manage boost and the intercooler pump is therefore unreliable.
Can I keep driving with code P00E0 active?
With caution: limp mode possible, have it checked soon
Common causes — P00E0
Faulty temperature sensor Pinched or chafed sensor wire touching ground Corroded, wet or bent connector terminals Wiring damaged by heat or vibration Faulty engine computer (rare)
How do you fix code P00E0?
First check the sensor connector and wiring for moisture, chafing or burn marks. Then the sensor resistance and signal should be measured with a proper tool. You can drive carefully for short trips, but don't leave it for long because the engine may limit power.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00DF — Charge air cooler coolant temp sensor A range/perf...
- Next code: P00E1 — Charge air cooler coolant temp sensor A: signal to...
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2