Skip to content
Fault code dictionary (DTC)

P00EA — Intake air temp sensor 3 bank 1: signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer read too low a voltage on intake air temperature sensor 3, bank 1. This usually points to a signal wire grounded or a shorted sensor. The computer interprets the value as an extremely high temperature, so it treats it as unreliable.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Loss of power
Unstable idle
Higher than usual fuel consumption
Possible limp mode

Common causes

Shorted sensor
Signal wire grounded by chafing
Wet or corroded connector
Wiring damaged by heat
Faulty engine computer (rare)

What to do

First check the connector and the wiring near the sensor, looking for pinched or burnt wires. Then the sensor resistance is measured. It is not an emergency, but it is best not to put it off.

How to read code P00EA

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P00EA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (EA) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P00EA mean?

Intake air temp sensor 3 bank 1: signal too low. The engine computer read too low a voltage on intake air temperature sensor 3, bank 1. This usually points to a signal wire grounded or a shorted sensor. The computer interprets the value as an extremely high temperature, so it treats it as unreliable.

Can I keep driving with code P00EA active?

With caution: limp mode possible, have it checked soon

Common causes — P00EA

Shorted sensor Signal wire grounded by chafing Wet or corroded connector Wiring damaged by heat Faulty engine computer (rare)

How do you fix code P00EA?

First check the connector and the wiring near the sensor, looking for pinched or burnt wires. Then the sensor resistance is measured. It is not an emergency, but it is best not to put it off.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes