Skip to content
Fault code dictionary (DTC)

P00EE — Intake air temp sensor 3 bank 2: reading not plausible

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer found that the signal from intake air temperature sensor 3, bank 2, is present but not plausible against other information, for example it stays fixed or differs too much from other sensors. The sensor is probably measuring incorrectly.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Slight loss of power
Rough idle
Fuel consumption varying for no obvious reason
No obvious symptoms in some cases

Common causes

Aged or dirty sensor
Connector with resistive contact
Damaged wiring
Sensor in a spot with abnormal heat
Fault in the air duct near the sensor

What to do

With the engine cold, compare this sensor's reading with the other temperature sensors using a scan tool: they should be similar. If it differs, check the sensor and connector. You can keep driving, but have it checked soon.

How to read code P00EE

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P00EE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (EE) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P00EE mean?

Intake air temp sensor 3 bank 2: reading not plausible. The engine computer found that the signal from intake air temperature sensor 3, bank 2, is present but not plausible against other information, for example it stays fixed or differs too much from other sensors. The sensor is probably measuring incorrectly.

Can I keep driving with code P00EE active?

With caution: limp mode possible, have it checked soon

Common causes — P00EE

Aged or dirty sensor Connector with resistive contact Damaged wiring Sensor in a spot with abnormal heat Fault in the air duct near the sensor

How do you fix code P00EE?

With the engine cold, compare this sensor's reading with the other temperature sensors using a scan tool: they should be similar. If it differs, check the sensor and connector. You can keep driving, but have it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes