P00F0 — Intake air temp sensor 3 bank 2: signal too high
| Meaning | The engine computer read too high a voltage on intake air temperature sensor 3, bank 2. It usually means a broken wire, an unplugged sensor, or a wire touching a power supply. The computer sees an extremely low temperature and does not trust the value. |
| Family | Powertrain (P) |
Typical symptoms
Hard cold starting
Rough idle
Loss of power
Variable fuel consumption
Common causes
Broken wire or corroded terminal
Faulty or open sensor
Signal wire touching a power supply
Faulty engine computer (rare)
What to do
How to read code P00F0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00F0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (F0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00F0 mean?
Intake air temp sensor 3 bank 2: signal too high. The engine computer read too high a voltage on intake air temperature sensor 3, bank 2. It usually means a broken wire, an unplugged sensor, or a wire touching a power supply. The computer sees an extremely low temperature and does not trust the value.
Can I keep driving with code P00F0 active?
With caution: limp mode possible, have it checked soon
Common causes — P00F0
Connector unplugged or loose Broken wire or corroded terminal Faulty or open sensor Signal wire touching a power supply Faulty engine computer (rare)
How do you fix code P00F0?
Make sure the connector is fully seated and the wires are not cut. Then the sensor and circuit should be measured with a multimeter. You can drive carefully, but have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00EF — Intake air temp sensor 3 bank 2: signal too low
- Next code: P00F1 — Intake air temp sensor 3 bank 2: erratic signal
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2