P0100 — Mass air flow sensor: general circuit fault
| Meaning | The engine computer detected a problem in the circuit of the sensor that measures how much air the engine draws in (the mass air flow sensor, or MAF). Without a reliable reading it cannot meter fuel properly. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle or engine stalling
Hesitation or jerking when accelerating
Loss of power
Higher fuel use than usual
Hard starting
Common causes
Damaged connector or wiring
Air leak after the sensor
Very dirty air filter
Problem with the sensor's supply or ground
What to do
How to read code P0100
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0100 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (00) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0100 mean?
Mass air flow sensor: general circuit fault. The engine computer detected a problem in the circuit of the sensor that measures how much air the engine draws in (the mass air flow sensor, or MAF). Without a reliable reading it cannot meter fuel properly.
Can I keep driving with code P0100 active?
Yes, no known limitation
Common causes — P0100
Dirty or faulty air flow sensor Damaged connector or wiring Air leak after the sensor Very dirty air filter Problem with the sensor's supply or ground
How do you fix code P0100?
First check the connector, the air filter and the intake pipes after the sensor. The car can usually be driven but with reduced performance, so have it diagnosed soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00FF — Body control module requested the check engine lig...
- Next code: P0101 — Mass air flow sensor: range/performance
Related codes
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible
- P010C — Air flow sensor B: signal too low