P010A — Mass air flow sensor B: circuit fault
| Meaning | The engine computer detected a problem in the circuit of the second air flow sensor (sensor B), which measures the amount of air drawn in. It is found on engines with two sensors, for example with two intake ducts. Exactly which sensor is B depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of power
Hesitation when accelerating
Higher fuel use
Engine in reduced mode
Common causes
Damaged connector or wiring
Air leak near the sensor
Dirty air filter
Sensor supply or ground problem
What to do
How to read code P010A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P010A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (0A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P010A mean?
Mass air flow sensor B: circuit fault. The engine computer detected a problem in the circuit of the second air flow sensor (sensor B), which measures the amount of air drawn in. It is found on engines with two sensors, for example with two intake ducts. Exactly which sensor is B depends on the manufacturer.
Can I keep driving with code P010A active?
With caution: limp mode possible, have it checked soon
Common causes — P010A
Dirty or faulty air flow sensor B Damaged connector or wiring Air leak near the sensor Dirty air filter Sensor supply or ground problem
How do you fix code P010A?
Check the connector, wiring and air duct of sensor B, and compare it with sensor A. Have it diagnosed soon, because the mixture may be wrong.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0109 — Manifold/barometric pressure sensor: intermittent...
- Next code: P010B — Air flow sensor B: signal out of range or implausi...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010B — Air flow sensor B: signal out of range or implausible
- P010C — Air flow sensor B: signal too low