P0105 — Manifold/barometric pressure sensor: general circuit fault
| Meaning | The engine computer detected a general problem in the circuit of the sensor that measures pressure in the intake manifold, and on some cars also atmospheric pressure. This reading is used to work out engine load and meter fuel. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of power
Hesitation when accelerating
Higher fuel use
Hard starting
Common causes
Faulty MAP sensor
Cracked or disconnected vacuum hose
Air leak in the manifold
Sensor supply or ground problem
What to do
How to read code P0105
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0105 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (05) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0105 mean?
Manifold/barometric pressure sensor: general circuit fault. The engine computer detected a general problem in the circuit of the sensor that measures pressure in the intake manifold, and on some cars also atmospheric pressure. This reading is used to work out engine load and meter fuel.
Can I keep driving with code P0105 active?
Yes, no known limitation
Common causes — P0105
Damaged sensor connector or wiring Faulty MAP sensor Cracked or disconnected vacuum hose Air leak in the manifold Sensor supply or ground problem
How do you fix code P0105?
Check the connector, the vacuum hose and any intake air leaks. You can drive carefully, but have it diagnosed soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0104 — Mass air flow sensor: intermittent signal
- Next code: P0106 — Manifold/barometric pressure sensor: implausible r...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible
- P010C — Air flow sensor B: signal too low