P0107 — Manifold/barometric pressure sensor: signal too low
| Meaning | The engine computer read too low a voltage from the pressure sensor. It may be an electrical fault, or the manifold pressure may really be lower than expected. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of power
Hesitation
Mixture too rich or dark smoke
Stalling
Common causes
Damaged or corroded connector
Faulty sensor
Vacuum leak in the circuit
Supply problem to the sensor
What to do
How to read code P0107
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0107 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (07) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0107 mean?
Manifold/barometric pressure sensor: signal too low. The engine computer read too low a voltage from the pressure sensor. It may be an electrical fault, or the manifold pressure may really be lower than expected.
Can I keep driving with code P0107 active?
Yes, no known limitation
Common causes — P0107
Sensor wire shorted to ground Damaged or corroded connector Faulty sensor Vacuum leak in the circuit Supply problem to the sensor
How do you fix code P0107?
Check the connector, wiring and supply of the sensor. If the engine stalls or runs badly, have it diagnosed soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0106 — Manifold/barometric pressure sensor: implausible r...
- Next code: P0108 — Manifold/barometric pressure sensor: signal too hi...
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible
- P010C — Air flow sensor B: signal too low