P010C — Air flow sensor B: signal too low
| Meaning | The engine computer is getting a voltage or signal from the second air flow sensor (sensor B) that is lower than the minimum allowed. To the computer it looks as if the engine is drawing in almost no air, even when it is not. This usually points to an electrical problem: missing power supply, a bad ground, a broken wire or a failed sensor. |
| Family | Powertrain (P) |
Typical symptoms
Engine stalls or struggles to keep running
Clear loss of power
Hard starting
Reduced performance because the car goes into limp mode
Common causes
Broken wire or a short to ground
Missing power supply or ground at the sensor
Faulty air flow sensor B
Faulty engine computer (rare)
What to do
How to read code P010C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P010C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (0C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P010C mean?
Air flow sensor B: signal too low. The engine computer is getting a voltage or signal from the second air flow sensor (sensor B) that is lower than the minimum allowed. To the computer it looks as if the engine is drawing in almost no air, even when it is not. This usually points to an electrical problem: missing power supply, a bad ground, a broken wire or a failed sensor.
Can I keep driving with code P010C active?
With caution: limp mode possible, have it checked soon
Common causes — P010C
Loose, corroded or bent-pin connector on air flow sensor B Broken wire or a short to ground Missing power supply or ground at the sensor Faulty air flow sensor B Faulty engine computer (rare)
How do you fix code P010C?
First check the connector and wires of sensor B for corrosion, moisture or torn cables. If the car stalls or goes into limp mode, avoid driving it, as it could leave you stranded in a dangerous spot.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P010B — Air flow sensor B: signal out of range or implausi...
- Next code: P010D — Air flow sensor B: signal too high
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible