P010F — Air flow sensors A and B: readings disagree
| Meaning | The engine computer compares the two air flow sensors and finds that the amounts of air they measure do not match, when they should be similar. It does not say which one is wrong. The problem may be in one of the sensors, an air leak in the intake or the wiring. This code applies to engines with two air flow sensors. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of power
Hesitation when accelerating
Fuel use that seems higher
Common causes
Air leak in one branch of the intake
Faulty air flow sensor
Intake duct partly blocked on one side
Damaged wiring or connector on one sensor
Sensors fitted or replaced incorrectly
What to do
How to read code P010F
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P010F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (0F) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P010F mean?
Air flow sensors A and B: readings disagree. The engine computer compares the two air flow sensors and finds that the amounts of air they measure do not match, when they should be similar. It does not say which one is wrong. The problem may be in one of the sensors, an air leak in the intake or the wiring. This code applies to engines with two air flow sensors.
Can I keep driving with code P010F active?
With caution: limp mode possible, have it checked soon
Common causes — P010F
One of the two air flow sensors is dirty or contaminated Air leak in one branch of the intake Faulty air flow sensor Intake duct partly blocked on one side Damaged wiring or connector on one sensor Sensors fitted or replaced incorrectly
How do you fix code P010F?
Inspect both branches of the intake, the hoses and the sensor connectors, looking for visible differences. You can drive carefully for short distances, but have the data from both sensors read soon to find out which one is wrong.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P010E — Air flow sensor B: intermittent or erratic signal
- Next code: P0110 — Intake air temperature sensor: circuit fault
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible