P0123 — Throttle Position Sensor Circuit High Input
| Meaning | The engine computer is receiving a voltage signal from the throttle position sensor that is higher than the maximum expected limit. This usually means the sensor is sending bad data about how far the accelerator pedal or throttle valve is open. |
| Family | Powertrain (P) |
Typical symptoms
The car might hesitate or not respond properly when you press the gas pedal
The vehicle may go into a safety limp mode with very limited power
Common causes
Damaged, corroded, or shorted wiring in the sensor harness
Internal failure within the engine control module
What to do
How to read code P0123
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0123 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (23) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0123 mean?
Throttle Position Sensor Circuit High Input. The engine computer is receiving a voltage signal from the throttle position sensor that is higher than the maximum expected limit. This usually means the sensor is sending bad data about how far the accelerator pedal or throttle valve is open.
Can I keep driving with code P0123 active?
With caution: limp mode possible, have it checked soon
Common causes — P0123
Faulty throttle position sensor or accelerator pedal position sensor Damaged, corroded, or shorted wiring in the sensor harness Internal failure within the engine control module
How do you fix code P0123?
You should have a mechanic inspect the wiring harness and connectors near the throttle body first. Drive the car as little as possible until it is checked, because unpredictable throttle response creates a serious safety risk on the road.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0122 — Throttle Position Sensor Low Voltage
- Next code: P0124 — Throttle/Pedal Position Sensor/Switch A Circuit In...
Related codes
- P0100 — Mass or Volume Air flow Circuit Malfunction
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass or Volume Air flow Circuit High Input
- P0104 — Mass or Volume Air flow Circuit Intermittent
- P0105 — Manifold Absolute Pressure/Barometric Pressure Circuit Malfu...
- P0106 — Manifold Absolute Pressure/Barometric Pressure Circuit Range...
- P0107 — Manifold Absolute Pressure/Barometric Pressure Circuit Low I...
- P0108 — Manifold Absolute Pressure/Barometric Pressure Circuit High...
- P0109 — Manifold Absolute Pressure/Barometric Pressure Circuit Inter...
- P0110 — Intake Air Temperature Circuit Malfunction
- P0111 — Intake Air Temperature Circuit Range/Performance Problem