P0122 — Throttle Position Sensor Low Voltage
| Meaning | The engine computer has detected an electrical signal from the throttle position sensor that is lower than the expected baseline. This sensor tells the computer how far down your foot is pressing the gas pedal, so a low reading means the system is not getting accurate throttle data. |
| Family | Powertrain (P) |
Typical symptoms
The car might idle roughly or stall when coming to a stop
Acceleration may feel sluggish or unresponsive
Common causes
A damaged or frayed wire in the sensor harness
A failing throttle position sensor itself
What to do
How to read code P0122
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0122 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (22) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0122 mean?
Throttle Position Sensor Low Voltage. The engine computer has detected an electrical signal from the throttle position sensor that is lower than the expected baseline. This sensor tells the computer how far down your foot is pressing the gas pedal, so a low reading means the system is not getting accurate throttle data.
Can I keep driving with code P0122 active?
With caution: limp mode possible, have it checked soon
Common causes — P0122
A poor connection or corrosion in the sensor wiring plug A damaged or frayed wire in the sensor harness A failing throttle position sensor itself
How do you fix code P0122?
Have a technician check the wiring plug and the sensor connector first for loose pins or corrosion. It is best to address this soon, as erratic throttle signals can make the car unpredictable to drive.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0121 — Throttle Position Sensor Performance Malfunction
- Next code: P0123 — Throttle Position Sensor Circuit High Input
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible