Skip to content
Fault code dictionary (DTC)

P012A — Turbo/supercharger inlet pressure sensor A circuit fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit has detected an electrical problem in the circuit of sensor A, which measures pressure at the inlet of the turbocharger or supercharger. The code points to a general circuit fault and does not say whether the signal is too high, too low or unstable.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Loss of power, especially under load
Sluggish throttle response
The engine may go into a reduced power mode
Higher than normal fuel use

Common causes

Broken, chafed or shorted sensor wiring
Corroded or poorly seated sensor connector
Faulty pressure sensor
Sensor supply or ground problems
Control unit fault, rare

What to do

Inspect the wiring and connector of the sensor, then have supply, ground and signal measured. If power drops a lot, avoid heavy loads and have it checked soon.

How to read code P012A

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P012A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (2A) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P012A mean?

Turbo/supercharger inlet pressure sensor A circuit fault. The control unit has detected an electrical problem in the circuit of sensor A, which measures pressure at the inlet of the turbocharger or supercharger. The code points to a general circuit fault and does not say whether the signal is too high, too low or unstable.

Can I keep driving with code P012A active?

With caution: limp mode possible, have it checked soon

Common causes — P012A

Broken, chafed or shorted sensor wiring Corroded or poorly seated sensor connector Faulty pressure sensor Sensor supply or ground problems Control unit fault, rare

How do you fix code P012A?

Inspect the wiring and connector of the sensor, then have supply, ground and signal measured. If power drops a lot, avoid heavy loads and have it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes