P0131 — O2 sensor bank 1 sensor 1: low voltage
| Meaning | The control unit saw that the signal from the oxygen sensor ahead of the catalytic converter, on the side of the engine with cylinder 1, stays too low. This sensor is used to adjust the air-fuel mixture, so the unit loses an important reference. The fault can be in the sensor, in its wiring, or in a real mixture problem. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Fuel use different from usual
Hesitation or stumbling
Smell of unburned fuel from the exhaust
Possible failure at an emissions test
Common causes
Damaged sensor wire or wire touching hot parts
Corroded or loose connector
Exhaust leak near the sensor
Lean mixture caused by another fault, such as an air leak
Less commonly, a faulty control unit
What to do
How to read code P0131
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0131 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (31) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0131 mean?
O2 sensor bank 1 sensor 1: low voltage. The control unit saw that the signal from the oxygen sensor ahead of the catalytic converter, on the side of the engine with cylinder 1, stays too low. This sensor is used to adjust the air-fuel mixture, so the unit loses an important reference. The fault can be in the sensor, in its wiring, or in a real mixture problem.
Can I keep driving with code P0131 active?
Yes, no known limitation
Common causes — P0131
Aged or faulty oxygen sensor Damaged sensor wire or wire touching hot parts Corroded or loose connector Exhaust leak near the sensor Lean mixture caused by another fault, such as an air leak Less commonly, a faulty control unit
How do you fix code P0131?
First check the sensor wiring and connector, and look for leaks at the exhaust manifold. You can use the car for a short time, but do not put it off for long: a wrong mixture over time can damage the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0130 — Oxygen Sensor Circuit Malfunction - Bank 1 Sensor...
- Next code: P0132 — Upstream O2 sensor bank 1: voltage too high
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible