P0199 — Engine oil temperature sensor signal intermittent
| Meaning | The control unit is receiving a signal from the engine oil temperature sensor that drops out, disappears or jumps in an unrealistic way. The fault comes and goes, so it may not be present when the car is tested. |
| Family | Powertrain (P) |
Typical symptoms
Oil temperature reading that jumps around or disappears, if fitted
Occasional reduced performance
Erratic cooling fan behaviour
The problem vanishes and returns with no clear pattern
Common causes
Wiring with a nearly broken conductor, often from vibration or rubbing
Oil temperature sensor on its way out
Unstable ground or supply to the sensor
Control unit fault, which is rare
What to do
How to read code P0199
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0199 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (99) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0199 mean?
Engine oil temperature sensor signal intermittent. The control unit is receiving a signal from the engine oil temperature sensor that drops out, disappears or jumps in an unrealistic way. The fault comes and goes, so it may not be present when the car is tested.
Can I keep driving with code P0199 active?
With caution: limp mode possible, have it checked soon
Common causes — P0199
Loose or corroded sensor connector Wiring with a nearly broken conductor, often from vibration or rubbing Oil temperature sensor on its way out Unstable ground or supply to the sensor Control unit fault, which is rare
How do you fix code P0199?
Check the sensor connector and wiring, gently moving them with the engine off to look for poor contacts. Also check the oil level. It is not normally an emergency, but an intermittent fault tends to get worse, so have it checked without waiting too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0198 — Engine oil temperature sensor signal too high
- Next code: P019A — O2 sensor 3 bank 1: slow response, rich to lean
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible