P01BB — Engine oil temperature sensor B: signal too low
| Meaning | The control unit found that the signal from the second (B) engine oil temperature sensor is below the normal range. This usually points to a short to ground in the wiring or a failed sensor. The oil is read as very hot or the data is invalid. |
| Family | Powertrain (P) |
Typical symptoms
Oil temperature gauge off scale
Fan running more than normal
Possible reduced performance
No obvious symptom in other cases
Common causes
Failed oil temperature sensor
Connector with oil or water inside
Control unit fault (rare)
What to do
How to read code P01BB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P01BB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (BB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01BB mean?
Engine oil temperature sensor B: signal too low. The control unit found that the signal from the second (B) engine oil temperature sensor is below the normal range. This usually points to a short to ground in the wiring or a failed sensor. The oil is read as very hot or the data is invalid.
Can I keep driving with code P01BB active?
With caution: limp mode possible, have it checked soon
Common causes — P01BB
Pinched or chafed wiring touching ground Failed oil temperature sensor Connector with oil or water inside Control unit fault (rare)
How do you fix code P01BB?
Check the sensor wiring and connector for rubbing, oil or moisture, and check the oil level. Keep an eye on the oil warning light and engine temperature, and have the car checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01BA — Engine oil temperature sensor B: implausible readi...
- Next code: P01BC — Engine oil temperature sensor B: signal too high
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible