P01C0 — Bank 2 fuel rail pressure sensor signal too low
| Meaning | The control unit detected that the electrical signal from the fuel rail pressure sensor on bank 2 is below the expected minimum. This is a problem with the sensor signal, which does not necessarily mean the real pressure is low. Without a reliable reading, the engine may be limited in power. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power or reduced-power mode
Hard or long cranking
Rough idle
Hesitation when accelerating
Common causes
Signal wire shorted to ground
Faulty pressure sensor
Missing or low sensor reference supply voltage
Faulty control unit (rare)
What to do
How to read code P01C0
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P01C0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (C0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P01C0 mean?
Bank 2 fuel rail pressure sensor signal too low. The control unit detected that the electrical signal from the fuel rail pressure sensor on bank 2 is below the expected minimum. This is a problem with the sensor signal, which does not necessarily mean the real pressure is low. Without a reliable reading, the engine may be limited in power.
Can I keep driving with code P01C0 active?
With caution: limp mode possible, have it checked soon
Common causes — P01C0
Damaged, corroded or broken wiring or connector at the sensor Signal wire shorted to ground Faulty pressure sensor Missing or low sensor reference supply voltage Faulty control unit (rare)
How do you fix code P01C0?
First check the connector and wiring of the bank 2 sensor for corrosion, chafed wires or loose terminals. Then read the sensor value with a diagnostic tool. Don't wait too long: the car may drop into limp mode and lose power in traffic.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P01BF — Fuel rail pressure sensor bank 2: implausible read...
- Next code: P01C1 — Bank 2 fuel rail pressure sensor signal too high
Related codes
- P0100 — Mass air flow sensor: general circuit fault
- P0101 — Mass air flow sensor: range/performance
- P0102 — Mass air flow sensor: signal too low
- P0103 — Mass air flow sensor: signal too high
- P0104 — Mass air flow sensor: intermittent signal
- P0105 — Manifold/barometric pressure sensor: general circuit fault
- P0106 — Manifold/barometric pressure sensor: implausible reading
- P0107 — Manifold/barometric pressure sensor: signal too low
- P0108 — Manifold/barometric pressure sensor: signal too high
- P0109 — Manifold/barometric pressure sensor: intermittent signal
- P010A — Mass air flow sensor B: circuit fault
- P010B — Air flow sensor B: signal out of range or implausible