Skip to content
Fault code dictionary (DTC)

P01C3 — Fuel pressure sensor A circuit fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit found a problem in the circuit of the fuel pressure sensor labelled A. The code is generic: it says the circuit is not correct, without saying whether the signal is low, high or unstable. The sensor may be on the fuel rail or on the fuel line, depending on the engine.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Loss of power
Hard starting
Rough idle
Abnormal fuel consumption

Common causes

Damaged wiring or connector at the sensor
Faulty fuel pressure sensor
Faulty sensor supply or ground
Short or break on the signal wire
Faulty control unit (rare)

What to do

Check the sensor connector and wiring, then read the pressure value with a diagnostic tool with the engine off and running. Also see whether other codes point to the same circuit. Do it soon, because the car may switch to an emergency strategy.

How to read code P01C3

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P01C3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (C3) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P01C3 mean?

Fuel pressure sensor A circuit fault. The control unit found a problem in the circuit of the fuel pressure sensor labelled A. The code is generic: it says the circuit is not correct, without saying whether the signal is low, high or unstable. The sensor may be on the fuel rail or on the fuel line, depending on the engine.

Can I keep driving with code P01C3 active?

With caution: limp mode possible, have it checked soon

Common causes — P01C3

Damaged wiring or connector at the sensor Faulty fuel pressure sensor Faulty sensor supply or ground Short or break on the signal wire Faulty control unit (rare)

How do you fix code P01C3?

Check the sensor connector and wiring, then read the pressure value with a diagnostic tool with the engine off and running. Also see whether other codes point to the same circuit. Do it soon, because the car may switch to an emergency strategy.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes