Skip to content
Fault code dictionary (DTC)

P01C6 — Fuel pressure sensor A circuit signal high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe signal voltage of sensor A is above the expected maximum. The control unit sees this as an electrical fault, such as a wire touching the supply or a lost ground. The pressure reading is not reliable and the engine may be limited.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Reduced power
Unstable idle
Hard starting
Irregular running

Common causes

Signal wire shorted to supply voltage
Sensor ground broken or corroded
Faulty pressure sensor
Damaged connector
Wire broken on the way to the control unit
Faulty control unit (rare)

What to do

First check the ground wire and connector of the sensor, then verify the reading with the engine off. Better not to wait, because without a correct reading fuel control can get worse.

How to read code P01C6

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P01C6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (C6) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P01C6 mean?

Fuel pressure sensor A circuit signal high. The signal voltage of sensor A is above the expected maximum. The control unit sees this as an electrical fault, such as a wire touching the supply or a lost ground. The pressure reading is not reliable and the engine may be limited.

Can I keep driving with code P01C6 active?

With caution: limp mode possible, have it checked soon

Common causes — P01C6

Signal wire shorted to supply voltage Sensor ground broken or corroded Faulty pressure sensor Damaged connector Wire broken on the way to the control unit Faulty control unit (rare)

How do you fix code P01C6?

First check the ground wire and connector of the sensor, then verify the reading with the engine off. Better not to wait, because without a correct reading fuel control can get worse.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes