Skip to content
Fault code dictionary (DTC)

P01CE — Cylinder 2 injection timing too early

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that injection start in cylinder 2 happens earlier than the requested value. Excessive advance can make combustion harsh and stress the engine. The cause may lie in the injector, pressure or the timing sensors.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Rough or noisy engine
Unusual knocking
Loss of power
Unstable idle
Smoke from the exhaust

Common causes

Faulty cylinder 2 injector or one that responds early
Incorrect fuel pressure
Crankshaft or camshaft sensors giving a wrong signal
Injector wiring or connector problems
Mechanical timing out of position
Faulty control unit (rare)

What to do

Look for other codes on fuel pressure and engine speed or phase sensors, then check the wiring and the cylinder 2 injector. If you hear metallic knocking, stop and have it checked right away, because early combustion can damage the engine.

How to read code P01CE

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P01CE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (CE) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P01CE mean?

Cylinder 2 injection timing too early. The control unit detected that injection start in cylinder 2 happens earlier than the requested value. Excessive advance can make combustion harsh and stress the engine. The cause may lie in the injector, pressure or the timing sensors.

Can I keep driving with code P01CE active?

With caution: limp mode possible, have it checked soon

Common causes — P01CE

Faulty cylinder 2 injector or one that responds early Incorrect fuel pressure Crankshaft or camshaft sensors giving a wrong signal Injector wiring or connector problems Mechanical timing out of position Faulty control unit (rare)

How do you fix code P01CE?

Look for other codes on fuel pressure and engine speed or phase sensors, then check the wiring and the cylinder 2 injector. If you hear metallic knocking, stop and have it checked right away, because early combustion can damage the engine.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes