Skip to content
Fault code dictionary (DTC)

P01EA — Coolant heater A control circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected a higher voltage than expected in the control circuit of heater "A". It can come from a wire touching the positive supply, or from a fault in the heater or its control.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Heater seems always on or never on
Uneven engine warm-up
Battery draining more than usual
No obvious symptom in normal driving

Common causes

Control wire touching the positive supply
Relay stuck closed
Coolant heater faulty
Damaged connector or bent terminals
Internal control unit fault (uncommon)

What to do

Check the relay, connector and wiring of the heater, looking for chafing or signs of overheating. If you notice a burning smell or the battery goes flat on its own, have the car checked right away.

How to read code P01EA

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P01EA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (EA) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P01EA mean?

Coolant heater A control circuit high. The control unit detected a higher voltage than expected in the control circuit of heater "A". It can come from a wire touching the positive supply, or from a fault in the heater or its control.

Can I keep driving with code P01EA active?

With caution: limp mode possible, have it checked soon

Common causes — P01EA

Control wire touching the positive supply Relay stuck closed Coolant heater faulty Damaged connector or bent terminals Internal control unit fault (uncommon)

How do you fix code P01EA?

Check the relay, connector and wiring of the heater, looking for chafing or signs of overheating. If you notice a burning smell or the battery goes flat on its own, have the car checked right away.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes