Skip to content
Fault code dictionary (DTC)

P0404 — EGR: control circuit range/performance

Severity: Warning Can you drive? Yes, no known limitation Make: All makes (OBD-II standard)
MeaningThe valve position read by the ECU does not match the commanded one. The electrical circuit is there, but the valve moves poorly or does not reach its target.
FamilyPowertrain (P)

Typical symptoms

Engine warning light on
Rough running at low revs
Reduced power

Common causes

Carboned valve moving in steps
Worn electric motor
Dirty position sensor
Corroded connector

What to do

Clean first, then run an actuation test on the diagnostic tool: if the valve still does not follow the command when clean, the fault is in the motor or built-in sensor and the unit is replaced.
Full guide: P0404: meaning, causes and solutions

How to read code P0404

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0404 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (04) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0404 mean?

EGR: control circuit range/performance. The valve position read by the ECU does not match the commanded one. The electrical circuit is there, but the valve moves poorly or does not reach its target.

Can I keep driving with code P0404 active?

Yes, no known limitation

Common causes — P0404

Carboned valve moving in steps Worn electric motor Dirty position sensor Corroded connector

How do you fix code P0404?

Clean first, then run an actuation test on the diagnostic tool: if the valve still does not follow the command when clean, the fault is in the motor or built-in sensor and the unit is replaced.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes