P0402 — EGR: excessive recirculation flow
| Meaning | More exhaust gas is entering the engine than intended. Usually the valve stays open when it should close, either because it is carboned up or because the actuator no longer pulls it back. |
| Family | Powertrain (P) |
Typical symptoms
Smoke and diesel smell
Reduced power
Hard hot starting
Common causes
Faulty diaphragm or actuator
Leaking vacuum control
Position sensor out of calibration
What to do
How to read code P0402
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0402 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (02) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0402 mean?
EGR: excessive recirculation flow. More exhaust gas is entering the engine than intended. Usually the valve stays open when it should close, either because it is carboned up or because the actuator no longer pulls it back.
Can I keep driving with code P0402 active?
Yes, no known limitation
Common causes — P0402
EGR valve not closing due to carbon Faulty diaphragm or actuator Leaking vacuum control Position sensor out of calibration
How do you fix code P0402?
Cleaning solves it when the problem is only dirt. If the valve cannot hold the closed position even when clean, it is worn and needs replacing.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usRelated codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance
- P040C — EGR temperature sensor 1 circuit low