P040C — EGR temperature sensor 1 circuit low
| Meaning | The control unit sees too low a voltage in the circuit of EGR temperature sensor 1. It usually means a wire shorted to ground or a shorted sensor, which the unit reads as an unrealistic temperature. As a result it can't properly control the exhaust gas recirculation. |
| Family | Powertrain (P) |
Typical symptoms
Higher emissions
Rough idle in some cases
Slight loss of power
Fuel consumption higher than normal
No obvious symptoms in the early stages
Common causes
Faulty EGR temperature sensor
Wet, corroded or damaged connector
Cable damaged by exhaust heat
Moisture or liquid in the connector
Control unit fault, which is rare
What to do
How to read code P040C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P040C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (0C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P040C mean?
EGR temperature sensor 1 circuit low. The control unit sees too low a voltage in the circuit of EGR temperature sensor 1. It usually means a wire shorted to ground or a shorted sensor, which the unit reads as an unrealistic temperature. As a result it can't properly control the exhaust gas recirculation.
Can I keep driving with code P040C active?
With caution: limp mode possible, have it checked soon
Common causes — P040C
Sensor wiring shorted to ground Faulty EGR temperature sensor Wet, corroded or damaged connector Cable damaged by exhaust heat Moisture or liquid in the connector Control unit fault, which is rare
How do you fix code P040C?
Inspect the wiring near the EGR valve and have the sensor's resistance and signal checked. You can usually keep driving, but it is best to have it diagnosed soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P040B — EGR temperature sensor 1 circuit performance
- Next code: P040D — EGR temperature sensor 1 circuit high
Related codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0406 — EGR sensor A circuit high
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance