P0406 — EGR sensor A circuit high
| Meaning | The control unit sees too high a voltage in the circuit of sensor A of the EGR system, which sends part of the exhaust gas back into the intake to reduce emissions. It may come from a wire touching supply voltage, a broken wire or a faulty sensor. With an out-of-limit signal, the recirculation isn't controlled correctly. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle or stalling at low rpm
Hesitation when accelerating
Loss of power
Higher emissions or abnormal smoke
Fuel consumption higher than normal
Common causes
Corroded connector or damaged terminals
Faulty EGR sensor
EGR valve with a faulty built-in sensor or stuck with soot
Wiring damaged by heat
Control unit fault, which is rare
What to do
How to read code P0406
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0406 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (06) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0406 mean?
EGR sensor A circuit high. The control unit sees too high a voltage in the circuit of sensor A of the EGR system, which sends part of the exhaust gas back into the intake to reduce emissions. It may come from a wire touching supply voltage, a broken wire or a faulty sensor. With an out-of-limit signal, the recirculation isn't controlled correctly.
Can I keep driving with code P0406 active?
Yes, no known limitation
Common causes — P0406
Signal wire shorted to supply voltage or broken ground wire Corroded connector or damaged terminals Faulty EGR sensor EGR valve with a faulty built-in sensor or stuck with soot Wiring damaged by heat Control unit fault, which is rare
How do you fix code P0406?
Have the EGR sensor wiring, connector and ground checked, then the valve with a diagnostic tool. Don't wait too long, because the engine is running with uncontrolled recirculation.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usRelated codes
- P0400 — Exhaust Gas Recirculation Flow Malfunction
- P0401 — EGR: insufficient recirculation flow
- P0402 — EGR: excessive recirculation flow
- P0403 — EGR control circuit
- P0404 — EGR: control circuit range/performance
- P0405 — EGR sensor A circuit low
- P0407 — EGR sensor B circuit low
- P0408 — EGR sensor B circuit high
- P0409 — Exhaust Gas Recirculation Sensor A Circuit
- P040A — EGR temperature sensor A circuit fault
- P040B — EGR temperature sensor 1 circuit performance
- P040C — EGR temperature sensor 1 circuit low