P0801 — Reverse inhibit control circuit fault
| Meaning | The control unit detected an electrical problem in the circuit that stops reverse from being engaged by mistake while driving forward. The circuit check does not give the expected values. The exact operation depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Reverse engaging when it should not
Transmission or engine warning light on
Reversing lights not working
Irregular shifting between first and reverse
Common causes
Faulty inhibit solenoid or actuator
Faulty reverse switch
Blown fuse or supply to the circuit
Faulty transmission control unit
What to do
How to read code P0801
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0801 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (01) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0801 mean?
Reverse inhibit control circuit fault. The control unit detected an electrical problem in the circuit that stops reverse from being engaged by mistake while driving forward. The circuit check does not give the expected values. The exact operation depends on the manufacturer.
Can I keep driving with code P0801 active?
With caution: limp mode possible, have it checked soon
Common causes — P0801
Poor wiring or connector in the circuit Faulty inhibit solenoid or actuator Faulty reverse switch Blown fuse or supply to the circuit Faulty transmission control unit
How do you fix code P0801?
Have the wiring, connectors and reverse switch checked. If reverse does not work or engages by itself while driving, do not drive the car and go to a workshop immediately.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0800 — Transfer case control system: warning light reques...
- Next code: P0802 — Transmission control MIL request circuit open
Related codes
- P0800 — Transfer case control system: warning light request
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault
- P080C — Upshift/skip shift solenoid circuit low