P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
| Meaning | The control unit detected an electrical problem in the circuit of the solenoid that forces the shift from first to fourth, used on some manual gearboxes to cut fuel use and emissions. This system exists only on certain models; the exact behaviour depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Difficulty engaging second or third at light load
Engine warning light on
Skip shift light always on or off
No obvious symptom in normal driving
Common causes
Faulty skip shift solenoid
Blown fuse or supply to the circuit
Faulty control unit
What to do
How to read code P0803
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0803 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (03) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0803 mean?
1-4 upshift (skip shift) solenoid control circuit fault. The control unit detected an electrical problem in the circuit of the solenoid that forces the shift from first to fourth, used on some manual gearboxes to cut fuel use and emissions. This system exists only on certain models; the exact behaviour depends on the manufacturer.
Can I keep driving with code P0803 active?
With caution: limp mode possible, have it checked soon
Common causes — P0803
Poor wiring or connector at the solenoid Faulty skip shift solenoid Blown fuse or supply to the circuit Faulty control unit
How do you fix code P0803?
Have the wiring, connectors and fuse of the solenoid checked and the data read with a diagnostic tool. You can usually keep driving, but the warning light shows a fault that should be checked fairly soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0802 — Transmission control MIL request circuit open
- Next code: P0804 — 1-4 upshift (skip shift) lamp control circuit faul...
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault
- P080C — Upshift/skip shift solenoid circuit low