P0804 — 1-4 upshift (skip shift) lamp control circuit fault
| Meaning | The control unit detected an electrical problem in the circuit of the lamp that tells the driver about the forced shift from first to fourth gear. It is a system found only on some manual-gearbox models; the exact behaviour depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Engine warning light on
No driving problem
Wrong indication on the dashboard
Common causes
Poor wiring or connector in the circuit
Faulty instrument cluster
Faulty control unit
What to do
How to read code P0804
This is an informational entry: it normally does not limit how the vehicle works.
The code P0804 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (04) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0804 mean?
1-4 upshift (skip shift) lamp control circuit fault. The control unit detected an electrical problem in the circuit of the lamp that tells the driver about the forced shift from first to fourth gear. It is a system found only on some manual-gearbox models; the exact behaviour depends on the manufacturer.
Can I keep driving with code P0804 active?
With caution: limp mode possible, have it checked soon
Common causes — P0804
Faulty bulb or LED of the lamp Poor wiring or connector in the circuit Faulty instrument cluster Faulty control unit
How do you fix code P0804?
Have the lamp circuit and its connection to the instrument cluster checked. Driving is usually not affected, but the engine warning light should be looked at to be sure.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0803 — 1-4 upshift (skip shift) solenoid control circuit...
- Next code: P0805 — Clutch position sensor circuit fault
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault
- P080C — Upshift/skip shift solenoid circuit low