P080C — Upshift/skip shift solenoid circuit low
| Meaning | This code is defined by the standard, but its exact use varies by manufacturer. The control unit detected too low a voltage in the circuit of the solenoid that commands an upshift or skip shift. It usually points to a short to ground or a solenoid with a faulty coil. |
| Family | Powertrain (P) |
Typical symptoms
Upshifts not performed or erratic
Transmission stuck in one gear
Harsh shifts
Limp mode
Common causes
Solenoid with a faulty coil
Damaged connector or oil inside it
Damaged internal transmission wiring
Faulty transmission control unit (uncommon)
What to do
How to read code P080C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P080C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (0C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P080C mean?
Upshift/skip shift solenoid circuit low. This code is defined by the standard, but its exact use varies by manufacturer. The control unit detected too low a voltage in the circuit of the solenoid that commands an upshift or skip shift. It usually points to a short to ground or a solenoid with a faulty coil.
Can I keep driving with code P080C active?
With caution: limp mode possible, have it checked soon
Common causes — P080C
Solenoid wire shorted to ground Solenoid with a faulty coil Damaged connector or oil inside it Damaged internal transmission wiring Faulty transmission control unit (uncommon)
How do you fix code P080C?
Have the solenoid wiring and connector checked, including any oil inside the connector. The transmission may lock into one gear, so don't delay too long. Don't clear the code without repairing the cause.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P080B — Upshift/skip shift solenoid circuit performance fa...
- Next code: P080D — Upshift/skip shift solenoid circuit high
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault