P080B — Upshift/skip shift solenoid circuit performance fault
| Meaning | This code is defined by the standard, but how it is used depends on the manufacturer and the type of transmission. In general the control unit found that the circuit of the solenoid commanding an upshift, or a skip shift, is not responding as expected. For the exact meaning on your car, the manufacturer's documentation is needed. |
| Family | Powertrain (P) |
Typical symptoms
Delayed or harsh upshifts
Skipped or missing gears
Transmission staying in one gear
Limp mode
Common causes
Wiring or connector with abnormal resistance
Dirty, low or degraded transmission fluid
Hydraulic problem in the valve body
Faulty transmission control unit (uncommon)
What to do
How to read code P080B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P080B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (0B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P080B mean?
Upshift/skip shift solenoid circuit performance fault. This code is defined by the standard, but how it is used depends on the manufacturer and the type of transmission. In general the control unit found that the circuit of the solenoid commanding an upshift, or a skip shift, is not responding as expected. For the exact meaning on your car, the manufacturer's documentation is needed.
Can I keep driving with code P080B active?
With caution: limp mode possible, have it checked soon
Common causes — P080B
Transmission solenoid sticking or working poorly Wiring or connector with abnormal resistance Dirty, low or degraded transmission fluid Hydraulic problem in the valve body Faulty transmission control unit (uncommon)
How do you fix code P080B?
First check the transmission fluid level and condition, and the solenoid wiring. If the transmission behaves abnormally, avoid heavy loads and long trips. A diagnosis with a tool suited to your make is needed.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P080A — Clutch position not learned
- Next code: P080C — Upshift/skip shift solenoid circuit low
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080C — Upshift/skip shift solenoid circuit low