P0805 — Clutch position sensor circuit fault
| Meaning | The control unit detected an electrical problem in the circuit of the sensor that tells whether the clutch pedal is pressed or released. Without this signal the system may not know when the clutch is engaged. The type of sensor used depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Stop-start function not working
Cruise control not engaging or switching off
Engine or transmission warning light on
Automated gearbox with irregular engagement
Common causes
Faulty clutch sensor or switch
Dirty or badly adjusted sensor
Blown fuse or supply to the sensor
Faulty control unit
What to do
How to read code P0805
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0805 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (05) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0805 mean?
Clutch position sensor circuit fault. The control unit detected an electrical problem in the circuit of the sensor that tells whether the clutch pedal is pressed or released. Without this signal the system may not know when the clutch is engaged. The type of sensor used depends on the manufacturer.
Can I keep driving with code P0805 active?
With caution: limp mode possible, have it checked soon
Common causes — P0805
Poor wiring or connector at the sensor Faulty clutch sensor or switch Dirty or badly adjusted sensor Blown fuse or supply to the sensor Faulty control unit
How do you fix code P0805?
Have the wiring and connector of the clutch sensor checked and its signal verified by pressing the pedal. If the car does not start or the clutch behaves irregularly, have it looked at soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0804 — 1-4 upshift (skip shift) lamp control circuit faul...
- Next code: P0806 — Clutch position sensor circuit range/performance f...
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault
- P080C — Upshift/skip shift solenoid circuit low