P0806 — Clutch position sensor circuit range/performance fault
| Meaning | The control unit receives the clutch sensor signal, but the values do not match the real position of the pedal or actuator. The electrical circuit may be fine: the problem is in the quality or consistency of the signal. The type of sensor depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Jerking when pulling away or changing gear
Difficulty starting the car
Engine or transmission warning light on
Stop-start or cruise control behaving irregularly
Common causes
Faulty clutch sensor
Worn clutch or actuator that moves poorly
Wiring or connector with a weak contact
Clutch pedal or control mechanism with abnormal play
What to do
How to read code P0806
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0806 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (06) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0806 mean?
Clutch position sensor circuit range/performance fault. The control unit receives the clutch sensor signal, but the values do not match the real position of the pedal or actuator. The electrical circuit may be fine: the problem is in the quality or consistency of the signal. The type of sensor depends on the manufacturer.
Can I keep driving with code P0806 active?
With caution: limp mode possible, have it checked soon
Common causes — P0806
Dirty, badly adjusted or misplaced sensor Faulty clutch sensor Worn clutch or actuator that moves poorly Wiring or connector with a weak contact Clutch pedal or control mechanism with abnormal play
How do you fix code P0806?
Have the sensor adjustment and condition checked, along with clutch wear. If you notice slipping or jerking when pulling away, do not wait: a clutch that works badly wears out quickly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0805 — Clutch position sensor circuit fault
- Next code: P0807 — Clutch position sensor signal too low
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault
- P080C — Upshift/skip shift solenoid circuit low