P0897 — Transmission fluid deteriorated
| Meaning | The transmission control unit has judged that the fluid has lost its protective properties, usually from wear or overheating. It does not necessarily mean the gearbox is already damaged, but the fluid is no longer protecting it as it should. How the unit reaches this conclusion varies from one manufacturer to another. |
| Family | Powertrain (P) |
Typical symptoms
Harsher shifts or jerking
Slipping or delayed gear engagement
Gearbox overheating when climbing hills or towing
Burnt smell from the transmission fluid
Slower gear changes when cold
Common causes
Severe use: towing, heavy city driving, long climbs
Gearbox overheating or an inefficient fluid cooler
Fluid level too low because of a leak
Wrong type of fluid for the gearbox
Degradation counter not reset after a fluid change
What to do
How to read code P0897
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0897 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (97) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0897 mean?
Transmission fluid deteriorated. The transmission control unit has judged that the fluid has lost its protective properties, usually from wear or overheating. It does not necessarily mean the gearbox is already damaged, but the fluid is no longer protecting it as it should. How the unit reaches this conclusion varies from one manufacturer to another.
Can I keep driving with code P0897 active?
With caution: limp mode possible, have it checked soon
Common causes — P0897
Fluid not changed within the recommended interval Severe use: towing, heavy city driving, long climbs Gearbox overheating or an inefficient fluid cooler Fluid level too low because of a leak Wrong type of fluid for the gearbox Degradation counter not reset after a fluid change
How do you fix code P0897?
Have the fluid level, colour and smell checked, and find out when it was last changed. If it is dark or smells burnt, do not put it off: driving long like this speeds up gearbox wear. Avoid towing and heavy loads until it has been checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0896 — Shift time too long
- Next code: P0898 — Transmission MIL request signal circuit low
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault