P0899 — Transmission MIL request signal circuit high
| Meaning | The automatic transmission uses a dedicated line to ask the engine control unit to switch on the warning light. The control unit detected a higher voltage than expected on this line. The fault is in the signalling connection, not necessarily in the gearbox mechanics. |
| Family | Powertrain (P) |
Typical symptoms
Other transmission codes stored along with this one
Gearbox in limp mode in some cases
No obvious driving symptoms
Possible inspection failure because of the warning light
Common causes
Broken line or loose connector
Corroded control unit connector
Wiring damaged by heat or rubbing
Internal fault in the transmission or engine control unit
Another transmission fault that triggers the request
What to do
How to read code P0899
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0899 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (8) points to transmission, and the last two (99) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0899 mean?
Transmission MIL request signal circuit high. The automatic transmission uses a dedicated line to ask the engine control unit to switch on the warning light. The control unit detected a higher voltage than expected on this line. The fault is in the signalling connection, not necessarily in the gearbox mechanics.
Can I keep driving with code P0899 active?
With caution: limp mode possible, have it checked soon
Common causes — P0899
Line wire shorted to a power supply Broken line or loose connector Corroded control unit connector Wiring damaged by heat or rubbing Internal fault in the transmission or engine control unit Another transmission fault that triggers the request
How do you fix code P0899?
Read all stored codes, because the request often comes from another transmission fault that should be dealt with first. Then check the wiring and connectors. If the gearbox behaves oddly, do not keep driving it.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0898 — Transmission MIL request signal circuit low
- Next code: P089A — Gear lever X position sensor 2 circuit fault
Related codes
- P0800 — Transfer case control system: warning light request
- P0801 — Reverse inhibit control circuit fault
- P0802 — Transmission control MIL request circuit open
- P0803 — 1-4 upshift (skip shift) solenoid control circuit fault
- P0804 — 1-4 upshift (skip shift) lamp control circuit fault
- P0805 — Clutch position sensor circuit fault
- P0806 — Clutch position sensor circuit range/performance fault
- P0807 — Clutch position sensor signal too low
- P0808 — Clutch position sensor signal too high
- P0809 — Clutch position sensor signal intermittent
- P080A — Clutch position not learned
- P080B — Upshift/skip shift solenoid circuit performance fault