P0B35 — High-voltage service disconnect circuit signal low
| Meaning | The control unit reads a lower than normal signal on the service disconnect circuit. This usually points to a short to ground or abnormal resistance in the circuit. The system may switch off the high voltage for safety. |
| Family | Powertrain (P) |
Typical symptoms
Car will not start or will not enter Ready
Loss of electric drive
High-voltage system fault message
Charging unavailable
Common causes
Wet or corroded disconnect connector
Pinched or chafed wiring
Faulty service disconnect
Fault in the control unit that powers or reads the circuit
What to do
How to read code P0B35
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0B35 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (35) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0B35 mean?
High-voltage service disconnect circuit signal low. The control unit reads a lower than normal signal on the service disconnect circuit. This usually points to a short to ground or abnormal resistance in the circuit. The system may switch off the high voltage for safety.
Can I keep driving with code P0B35 active?
With caution: limp mode possible, have it checked soon
Common causes — P0B35
Control circuit wire touching ground Wet or corroded disconnect connector Pinched or chafed wiring Faulty service disconnect Fault in the control unit that powers or reads the circuit
How do you fix code P0B35?
Do not touch high-voltage parts: have a qualified technician handle it. The check starts with the wiring and connector at the disconnect, looking for moisture or chafing. Do not keep trying to start the car repeatedly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0B34 — High-voltage service disconnect circuit performanc...
- Next code: P0B36 — High-voltage service disconnect circuit signal hig...
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B02 — Electric transmission fluid pump: phase U current too high
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high